Search Catalog
      GO   
 All Categories    72SA Tee (Compression x Male Pipe)
All Categories > Hose & Fittings > Fittings > Brass Self-Aligning Compression Fittings > 72SA Tee (Compression x Male Pipe) > Item # 00272-0808  
Download PDF Download PDF     Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Item # 00272-0808, 72SA Tee (Compression x Male Pipe)



Features:
• Sleeve and nut permanently attached
• Sleeve is visible after installation, helping to eliminate misaligned sleeves
• Two piece construction – nut and body
• Use with copper, brass, aluminum, or plastic tubing (plastic requires insert 61P)
• –65° to +250° F. temperature range
• Quicker assembly than flare or regular compression
• Better vibration resistance than regular compression fittings
• Can be used anywhere a regular compression fitting is used, especially when installation may be difficult

To Assemble:
1. Cut smooth, square end on tubing
2. Slide nut over tube, threads facing end
3. Insert tube into fitting
4. Thread nut onto fitting until snug, then one more turn






 Specifications   

Tube OD

1/2 x 1/2

Note

These products contain lead and are NOT ALLOWED by Federal Law to be installed for POTABLE WATER use in the U.S.A. and its territories. WARNING: Furthermore, these products contain a chemical known to the State of California to cause cancer, birth defects or other reproductive harm.

Manufacturer

Anderson Metals Corporation