JEC Products & Systems............................................ Bulk Tanker Blowers Butterfly Valves & ActuatorsConcrete Batch PlantsConcrete Plant AutomationContinuous MixersConveyor AccessoriesConveyor ProductsDust Control SystemsHopper Car Unloading SystemsHose and FittingsLevel IndicationMetal Fiber DispensersMotion ControlsOverhead DistributionSystemsPiggyback Hopper FramePillow BlockPlanetary MixersPost Drivers & Post PullersRadio Remote ControlScales and Load CellsSilo & Silo AccessoriesSilo Aeration ProductsSilo Anti-Overfill SystemsSolenoid Valves, Air Cylinders & Airline Accessories Ticket Delivery SystemTurbine MixersTwin Shaft MixersVibrating ScreensVibratorsWater Meters, Water Heaters/Chillers & Steam Generators JEC Services............................................Plant & System AssemblyField Services Engineered Retrofits
Features:• NPN open collector, square-wave output• Zero speed operation with no signal loss• Non-contact, large gap distance sensing • Signal transmits up to 1,500 ft • Simple to install and set up• Powered by 5-24 VDC
These speed sensors use magnet-sensing Hall Effect IC's to produce a digital pulse signal to interface with speed switches, tachometers, counters, signal conditioners, or PLC's. Hall Effect sensors provide true zero speed operation with square-wave output and immunity to electrical noise.
A pulser disc or split collar pulser wrap with embedded magnets is mounted on the monitored shaft. As the shaft rotates, the magnets pass in front of the sensor causing the sensor to switch high and low, thus producing a digital pulse output. The sensors provide a digital square wave signal with a 50/50 duty cycle when used with pulse generators that have evenly spaced magnets of alternating polarity, such as Electro-Sensors Model 255 Pulser Disc. The recommended gap distance between the sensor and pulse generator is 1/4 inch +/- 1/8 inch. The gap flexibility makes the sensors tolerant of vibration, shaft run-out, misalignment, and industrial environments.
931 XP (Explosion Proof)• Class I, Div I (C, D) Class II, Div I (E, F, G) Class III• XLB-1 enclosure• The 931 XP is mounted in a cast aluminum enclosure and is supplied with a mounting bracket and 10 feet of 3-conductor shielded cable. The conduit opening is 1/2 inch NPT.
