Features:
• Sleeve and nut permanently attached
• Sleeve is visible after installation, helping to eliminate misaligned sleeves
• Two piece construction – nut and body
• Use with copper, brass, aluminum, or plastic tubing (plastic requires insert 61P)
• –65° to +250° F. temperature range
• Quicker assembly than flare or regular compression
• Better vibration resistance than regular compression fittings
• Can be used anywhere a regular compression fitting is used, especially when installation may be difficult

To Assemble:
1. Cut smooth, square end on tubing
2. Slide nut over tube, threads facing end
3. Insert tube into fitting
4. Thread nut onto fitting until snug, then one more turn

Request Information
Items
78SA Tee

78SA Tee (Compression x Female Pipe)
78SA Tee

78SA Tee (Compression x Female Pipe)
78SA Tee

78SA Tee (Compression x Female Pipe)
78SA Tee

78SA Tee (Compression x Female Pipe)
78SA Tee

78SA Tee (Compression x Female Pipe)
Tube OD N/A 1/4 x 1/8 N/A 1/4 x 1/4 N/A 3/8 x 1/8 N/A 3/8 x 1/4 N/A 3/8 x 3/8
Note N/A These products contain lead and are not allowed by Federal Law to be installed for potable water use in the U.S.A. and its territories. WARNING: Furthermore, these products contain a chemical known to the State of California to cause cancer, birth defects
Manufacturer N/A Anderson Metals Corporation