Products Catalog

With Full Rated Wired Emergency Bypass

Features:
• Separate start and run overload protection:
• Two programmable overload trip curves allow for the thermal
• capacity required to start the load, while providing more closely
• matched overload protection during the run time.
• Integral bypass contactors are standard on all sizes
• and can soft start most any load.
• Real-time thermal modeling a dynamic thermal register
• continuously calculates motor operating temperature
• even when your motor isn't running.
• PTC thermistor input for use on motors with embedded
• PTC temperature sensors.
• Current imbalance trip and biasing of the thermal register.
• Electronic shear pin trip (overcurrent) with trip delay.
• Phase loss protection bases on current and voltage.
• Equipment ground fault trip and monitoring.
• Load loss trip (under current) with trip delay.
• Pre-start shorted load protection checks for motor lead
• or winding damage.

Power Components:
• 6 SCRs in inverse parallel pairs for full phase angle soft start control
• 1600V PIV rating on all units
• RC snubber for dv/dt protection of each SCR pair

Line Voltage Range:
• 200 to 600 VAC, 3 phase + 10%-15%,  50/60 Hz

Current Ratings:
• 18 to 800A depending on unit selection
• Range of each unit is 50-100% of maximum

AC Supply Voltage:
• User supplied 120VAC + 10%-15% tolerance, 60 Hz
• Optional 240VAC 50 Hz control available

Start / Stop Control Choices:
• 2-wire Run-Stop using dry contacts
• 3-wire Start/Stop with built-in seal in contact
• N.C. Interlock input (dry contact) for remote devices

Ramp Control Choices (4 built-in):
• Voltage Ramp
• Voltage Ramp with Current Limit
• CLT© Closed Loop Torque Ramp (Current Ramp)
• Current Step (current limit only)
• Ramp times adjustable 1-120 seconds
• Current limit adjustable 200-600% of FLA

Kick Start:
• 10-100% starting torque for 0.1-2 seconds

Worldwide Electric’s Non-Combination Softstart package is ideal for those applications where control and circuit protection is already in place. This product is ideal for retrofit applications, or any applications where your fused disconnect is already in place. It is economical, yet still has the robust Worldwide softstart chassis inside.

Now available with integrated surge protection device (SPD), this soft starter has all of the features and protection for any application.

Features:
• With motor-saver technology
• Same NEMA 4/12 enclosure as combination unit
• Service Entrance Rated
• Auto-synchronization
• Heavy duty full voltage rated integral bypass
• 120 Volt controls power transformer
• Programmable electronic overload
• Two pre-punched holes for optional controls
• White powder coated finish

Worldwide Electric’s EPIC Softstart package is an economical alternative for pump, fan, and conveyor softstart applications that do not require an emergency bypass. The Run-Off-Auto selector switch makes it ideal for remote irrigation applications, yet it is also ideal for industrial applications that will tie into a PLC control system.

Now available with integrated surge protection device (SPD), this soft starter has all of the features and protection for any indoor or outdoor general purpose application.

Features:
• Service entrance rated
• Simple operation / easy to use
• NEMA 4 enclosure
• Full panel surge protection
• Advanced motor protection
• Circuit breaker and door operator disconnect (fused disconnect on 20 HP and 25HP)
• Three wire in, three wire out installation
• REMOTE / OFF / ON selector switch for local or remote operation
• Full three leg power starter
• Start rated bypass with x-line mode
• Overload rated 500% for 30 seconds
• Pump ramp down feature - eliminates water hammer
• Emergency stop pushbutton
• Illuminated reset pushbutton
• Run pilot light
• wwEPIC soft starts are suitable for all general purpose applications